Metrohm MIPT technique in ion chromatography
Metrohm has released a technical article/application note focusing on the use of its Metrohm Intelligent Partial Loop (MIPT) technique in ion chromatography.
When using ion chromatography, in order to avoid overloading of the separation column and achieve the best detection limits for analysis, it is often necessary to adjust the injection loop volume to the concentration of the sample.
With the MIPT it is possible to inject different sample volumes with just one fixed injection loop, which allows a range of sample concentrations to be analysed without any changes to the system and also to perform a multi-point calibration with just one multi ion standard.
Due to the logical features of the MagIC Net controlling software, the partial loop technique can be used as an alternative to intelligent dilution and could also be combined with other techniques, such as ultra-filtration.
The MIPT setup can be added to any 850 Professional IC, 881 Compact IC pro or 882 Compact IC plus in combination with the intelligent 800 Dosino and 858 professional sample processor with rinsing station.
The Dosino dosing unit allows sample volumes between 2-200ul to be injected quickly and precisely into the ion chromatography instrument and this principle can be applied to the calibration standards so that it is possible to prepare a mg 1-1 to ug 1-1 calibration with no handling of individual standards, which can be both time consuming and introduce possible errors.
The 800 Dosino is used to aspirate an excess of sample through the injection valve into a buffer tubing to purge all sample lines.
The injection valve is then switched to the fill position and an adjustable amount of sample (2-200ul) is transferred from the buffer tubing into the 250ul sample loop.
The injection valve is finally switched back to the inject position and the sample is introduced onto the separation column and analysed.
The sample handling time is around three minutes and during the chromatographic run the buffer tubing is purged with ultrapure water.
The rinse station located on the edge of the sample processor is essential for trace-level analysis and rinsing of the needle with a fresh source of ultra-pure water each time.
Tests have shown carryover to be less than 0.001 per cent as a result of the Dosino pull mode technique.
The versatility and convenience of MIPT allows sample concentrations in the range 1:10,000 to be analysed with the same instrument configuration with no additional time-consuming rinsing procedures between different kinds of sample and allows flexibility when used in day-to-day laboratory work.
MIPT is said to save money, shorten sample-preparation time to reduce the analytical workload within the laboratory, extend the measuring range and improve the accuracy and reproducibility of results.
A new agreement with FOSS is set to make Metrohm the sole global distributor of FOSS NIR instruments.
A recent study by the University of Campinas in Brazil has confirmed the suitability of ion chromatography (IC) for quality control of biodiesel.
Metrohm has introduced the QuickTOCpharma system for the detection of total organic carbon (TOC) in pharmaceutical water
Metrohm has increased its automation portfolio for ion chromatography with the launch of the 919 IC entry-level autosampler
Metrohm has introduced the Ti-Touch, a compact titrator for routine analysis.