Latest news on Laboratorytalk categorised by supplier
Moore Industries International
Please note: More news from Moore Industries International on the Processingtalk web site
Address:
16650 Schoenborn Street
North Hills
CA 91343
USA
Telephone: (USA) +1 818 891 7111
http://www.miinet.com
Our RSS feed for news from Moore Industries International
Request to receive our free email newsletter each week
Listing of all 13 news releases from Moore Industries International:
Charles Larson promoted to director of technology
Charles Larson has been promoted to director of technology at Moore Industries-International; Larson currently is software development manager, and will continue in that capacity
News from Moore Industries International (11 May 2007)
Tina Lockhart promoted to director of engineering
Effective immediately, Tina Lockhart is promoted to director of engineering at Moore Industries-International
News from Moore Industries International ( 3 May 2007)
Data acquisition system baked in endurance test
Moore Industries has been continuously running its NCS data acquisition system at temperatures around 100C for more than two years in an environmental chamber, just to prove a point
News from Moore Industries International (26 April 2007)
Brochure covers full line of temperature sensors
Temperature line card brochure describes the full line of sensors, transmitters and assemblies from Moore Industries.
News from Moore Industries International (19 March 2007)
Bimetal temperature sensor provides local readout
The Bimetal dual-mode remote thermometer provides on-site indication of process temperature conditions, and simultaneously provides a mV or ohm signal proportional to temperature
News from Moore Industries International ( 2 March 2007)
Moore Industries signs Arjay as representative
Moore Industries-International has signed Arjay Automation in Minneapolis, Minnesota, as a manufacturer's representative for all Moore Industries product lines, including MooreHawke
News from Moore Industries International (23 February 2007)
Alarm trips monitor, control, shut down processes
Moore Industries's Spa2 programmable current/voltage and RTD/thermocouple limit alarm trips received FM approval, allowing them to be used in hazardous locations
News from Moore Industries International (19 January 2007)
Downloadable paper give introduction to fieldbus
Technical background article The 'Introduction to Fieldbus' white paper explains, in terms any engineer, technician or operator can understand, how fieldbus works
News from Moore Industries International (13 October 2006)
Fieldbus device coupler works in hazardous areas
The TG300 Trunkguard device couplers make connecting Foundation Fieldbus H1 or Profibus PA fieldbus devices in Zone 1 and 2 hazardous locations easy and inexpensive compared to traditional methods
News from Moore Industries International ( 9 October 2006)
High-accuracy wall-mount room temperature monitor
T2X-DWB uses a precision 1000ohm platinum RTD to provide highly-accurate temperature readings (+/-0.5C input accuracy with +/-0.1% of span output accuracy)
News from Moore Industries International (29 June 2006)
Temperature transmitter saves installation costs
Moore Industries's TPZ Profibus PA temperature transmitter saves wire and installation costs by allowing up to 32 field devices (126 with repeaters) to be networked onto one low-cost data link
News from Moore Industries International (15 May 2006)
New Middle East office for process control firm
A new sales and service office in Bahrain will support Moore Industries' expanding customer base in the Middle East
News from Moore Industries International (17 May 2004)
Networking goes wireless
This bi-directional wireless ethernet module employs intelligent spectrum frequency hopping technology and 32-bit CRC error correction for secure, robust communications
News from Moore Industries International (15 March 2004)
