Product category:
Microbiology
News Release from: Oxoid | Subject: Contact Plates and Dip Slide
Edited by the Laboratorytalk Editorial
Team on 18 September 2003
Ensuring clean surfaces in hospitals
Two choices of sampler - contact plates and dip slides - which can be used to determine density of micro-organisms or colony-forming units on hospital surfaces
As hospitals come under increasing scrutiny in terms of their performance, there is growing pressure on Trusts to demonstrate commitment to providing the best care and environment for patients No matter how successful a particular treatment is, patient recovered can be severely hampered by an infection picked up in hospital and there is the potential of rapid transmission of disease, unless good hygiene and infection control procedures are in place
This article was originally published on Laboratorytalk on 18 Jan 2002 at 8.00am (UK)
Related stories
Test to detect C difficile toxin A
Clostridium difficile is thought to be present in up to a fifth of hospital patients, and can cause the life-threatening condition PMC. Oxoid reports continuing sales growth for its diagnostic test
Culture medium for water quality monitoring
Oxoid has launched its water plate count agar, a medium to permit the enumeration of culturable micro-organisms from water using a colony count technique
There are certain 'high risk' areas, where the monitoring of cleanliness can serve to protect the most vulnerable of patients - operating theatres, intensive care units, special care baby units and treatment rooms.
In such areas, the efficiency of cleaning procedures can be monitored by testing certain surfaces (particularly those that will come into contact with patients and staff) for the presence of micro-organisms that can cause disease or infection.
Sampling of surfaces can be performed using Oxoid Contact Plates.
Further reading
New media for VRE screening
Oxoid has launched a range of products for the isolation and presumptive identification of vancomycin resistant enterococci and high level aminoglycoside resistant enterococci
Rapid visual identification of MRSA
Oxacillin resistance screening agar base (Orsab) is a new medium from Oxoid that uses aniline blue to detect mannitol fermentation in Staphylococci; free poster offered
A sample is taken by gently rolling the domed surface of the agar (the jelly-like medium contained in the plate) onto the area to be tested.
If any micro-organisms are present, they will grow to form easily visible colonies on the surface of the agar.
This offers a reliable and effective way of determining the microbial cleanliness of surface areas.
An alternative to the contact plate is the Oxoid Dip Slide.
This is a plastic slide, coated with an even layer of agar on both sides.
This allows two tests to be performed at one time, and increases the detection potential of the method.
A flexible hinge between the handle and the slide itself, allows the entire surface of the medium to be gently and evenly pressed onto the area to be tested.
Once samples have been taken, the plates should be covered (Dip Slides returned to their containers) and transported to the laboratory to be incubated appropriately and examined for growth.
Each colony represents one micro-organism or colony forming unit (CFU) on the area sampled.
The bases of Contact Plates and slides are sub-divided into grids to allow easy calculation of CFU per cm2 from surface tests.
The laboratory is then able to report back whether these levels fall within pre-defined acceptable limits.
The measurement of cleanliness in hospitals goes beyond what can be seen by eye.
Invisible dangers of microbial contamination can cause the most harm and Trusts will be expecting cleaning contractors to demonstrate extra care and attention in this critical area of hygiene assurance. Request a free brochure from Oxoid ...
• Oxoid: contact details and other news
• Email this article to a colleague
• Register for the free Laboratorytalk email newsletter
• Laboratorytalk Home Page
Search the Pro-Talk network of sites
