PBSC, a supplier of pass-through cabinets and material air locks (MALs), has chosen to use the hydrogen peroxide vapour (HPV) system from Bioquell.
The result is decontamination at below 30C with a cycle time of approximately one hour (load dependent).
This system achieves a 6-log reduction or 99.9999% reduction of bacteria (using G stearothermophilus spores) validated during gas cycle development.
The vaporised hydrogen peroxide MAL is manufactured in module format for installation into existing facilities and laboratories without lengthy and expensive downtime.
The units are manufactured from 304 or 316L grade stainless steel and incorporate PBSC's inflatable seal doors.
The decontamination airlocks are fitted flush to the floor allowing easy access for wheeled items and doing away with the trip hazard of a raised threshold or the need for a pit.
The control system continually monitors the integrity of all seals and with no ducting or venting required the sterilisation chamber needs only power and compressed air services.
With a cycle time of approximately one hour, PBSC decontamination MAL units are ideally suited for the transfer of materials requiring bio-decontamination.
The hydrogen peroxide vapour is compatible with most materials and leaves no post-process residue.
In combination with the low processing temperature, it is ideal for computers, electronic equipment, heat sensitive materials and other non-autoclavable items.
